Difference between revisions of "Spectrum"

From IoTWiki
Jump to: navigation, search
(convergence)
(National Allocation)
 
(4 intermediate revisions by the same user not shown)
Line 23: Line 23:
  
 
===National Allocation===
 
===National Allocation===
The National Frequency Allocation plan (NFAP) 2011 provides for  
+
The National Frequency Allocation plan (NFAP) 2011 provides for 2 MHZ in 865 MHZ band  
*2 MHZ in 865 MHZ band
+
for short range devices (SRD) communication which can be used for IoT (M2M).Car remote controls use 433 Mhz and that too can be used
*2 MHz in 433 MHz band
+
 
for short range communication which can be used for IoT (M2M)
+
There is power and duty cycle restriction for unlicensed band operation
 +
 
 +
*1 % Duty cycle
 +
*10mW/Mhz for 433 MHz and 1 W peak and 4W ERP for 865 MHz
 +
 
 
It notes
 
It notes
 
;Ultra Wideband (UWB): UWB is a short range low power technology that
 
;Ultra Wideband (UWB): UWB is a short range low power technology that
Line 85: Line 89:
  
 
In India the 865 MHz to 867 MHz license free band in India ends at 867 MHz, as per the Ministry of Communications and Information Technology directions as mentioned here despite being in  the ITU. However the 868 MHz LoRa band has 8 channels and 7 of 8 frequency channels are in the license free 865 MHz – 867 MHz band in India.
 
In India the 865 MHz to 867 MHz license free band in India ends at 867 MHz, as per the Ministry of Communications and Information Technology directions as mentioned here despite being in  the ITU. However the 868 MHz LoRa band has 8 channels and 7 of 8 frequency channels are in the license free 865 MHz – 867 MHz band in India.
===TRAI Recommendation for M2M Spectrum===
+
==TRAI Recommendation for M2M Spectrum==
 
Industry recommendations for 10MHz were considered .
 
Industry recommendations for 10MHz were considered .
 
  Request for unlicensing were 433-434 MHz, 902-928 MHz, 1880-1900 MHz, 2483-2500 MHz, 5150-5350 MHz, and 5725-5775 MHz. These demands reflect the widespread market adoption in countries where these bands have already become unlicensed.
 
  Request for unlicensing were 433-434 MHz, 902-928 MHz, 1880-1900 MHz, 2483-2500 MHz, 5150-5350 MHz, and 5725-5775 MHz. These demands reflect the widespread market adoption in countries where these bands have already become unlicensed.
Line 112: Line 116:
  
 
==see Also==
 
==see Also==
 +
*[[M2M Regulation]]
 
*https://www.itu.int/en/ITU-D/Conferences/GSR/Documents/GSR2015/Discussion_papers_and_Presentations/GSR15_session5_Brown.pdf
 
*https://www.itu.int/en/ITU-D/Conferences/GSR/Documents/GSR2015/Discussion_papers_and_Presentations/GSR15_session5_Brown.pdf
 
*https://www.brookings.edu/wp-content/uploads/2016/06/Spectrum-Policy-in-India8515.pdf
 
*https://www.brookings.edu/wp-content/uploads/2016/06/Spectrum-Policy-in-India8515.pdf
 +
 +
[[Category:Regulations]]

Latest revision as of 04:41, 7 November 2017

Spectrum[edit]

Spectrum is divided into licensed and unlicensed. Licensed spectrum is typically provided to telecom operators who provide voice and data services. End users must obtain these services from a licensed operator and can not use these resources (even for own internal non commercial use ) Unlicensed spectrum can be used by anyone but is subject to stricter limits on power radiated and duty cycle .


electro_spectrum_all_1.png

As a rule Higher frequency means higher data bandwidth but lesser range. Sub GHZ can more easily penetrate cement walls, tree coverage and at extreme cosmic rays can penetrate deep underground.


The ITU Defines regions and a global frequency allocation of spectrum. This includes a common ISM( Industry, Scientific and ) band

ITU%20regions.jpg

International ISM bands[edit]

ITU defined a industrial, scientific, and medical radio band (ISM band) which is commonly used worldwide. WiFi, Bluetooth etc operate in the 2.4 GHz ISM band. ITU Frequency Allocation table(FAT) has served well.

Dividend-Specturm-FAT-Backed.png

This is under stress as capacity is much less then demand and newer technologies like IoT are moving faster then international harmonization efforts.As a result different countries have different allocations.

convergence[edit]

The ITU is running a convergence and global harmonization process. China has adopted 700MHz and USA 900 MHZ band for IoT.

National Allocation[edit]

The National Frequency Allocation plan (NFAP) 2011 provides for 2 MHZ in 865 MHZ band for short range devices (SRD) communication which can be used for IoT (M2M).Car remote controls use 433 Mhz and that too can be used

There is power and duty cycle restriction for unlicensed band operation

  • 1 % Duty cycle
  • 10mW/Mhz for 433 MHz and 1 W peak and 4W ERP for 865 MHz

It notes

Ultra Wideband (UWB)
UWB is a short range low power technology that

will enable a range of applications such as WPANs (information technology / multimedia entertainment / consumer applications), public protection, construction, engineering, science, medical and transportation. Its low energy feature enables unique coexistence properties that allow UWB to operate as an unlicensed wireless technology in presence of other licensed service without causing harmful interference to them. This feature has the effect of increasing spectral efficiency by enabling reuse of spectrum.These devices will also implement next generation cognitive concepts such as Detect and Avoid (DAA) to ensure coexistence with primary users.

Intelligent Transport System (ITS)
ITS may be defined as systems

utilizing a combination of computers, communications, positioning and automation technologies to use available data to improve the safety, management and efficiency of terrestrial transport, and to reduce environmental impact. One of the major communication mode in these systems is Digital Short Range communication (DSRC) systems. These devices are mounted on the roadside and the corresponding transceivers are on board the vehicle. Such devices operate over 5-10 MHz bandwidth, with transmit power up to 8 Watts

E- band Radio
Developments in millimetre wave radio technology have

caused interest in E-band Wireless as it provides alternative frequency bands for multi-megabit and even gigabit per second speed required by newer generation communication and multimedia services.


Unlicensed Frequency Ranges in India Application/Specifications
Frequency Usage
50-200 kHz Very low power devices 13553-13567 kHz Very low power radio frequency devices, indoor onlycell
26.957 MHz-27.283 MHz Low power wireless equipment (max. Effective Radiated Power of 5 watts)
335 MHz Low power wireless equipment for the remote control of cranes
402-405 MHz Medical RF wireless devices (max. radiated power of 25 microwatt) with channel emission band width within 300 kHzcell
432-438 MHz Radiolocation Amatuer
865-867 MHz Low power wireless device (max. transmitter power of 1 watt-4 watts Effective Radiated Power) with 200 kHz carrier bandwidth
Radio Frequency Identification Devices (RFID) (MTP of 1 watt-4 watts ERP) with 200 kHz carrier band width
2400 MHz - 2483.5 MHz Low power wireless equipment (e.g. Wi-Fi) (max. transmitter output power of 1 watt-4 watts ERP) with spectrum spread of 10 MHz or higher
5150 MHz-5350 MHz Low power equipment for Wireless Access Systems (max. mean Effective Isotropic Radiated Power of 200 mW and max. mean Effective Isotropic Radiated Power density of 10 mW/MHz in any 1 MHz bandwidth) indoor only
5725 MHz-5825 MHz Low power equipment for Wireless Access Systems (MMEIRP of 200 mW and MMEIRP density of 10 mW/MHz in any 1 MHz bandwidth) indoor only
5825 MHz- 5875 MHz Low power equipment (MTOP of 1 watt-4 watts ERPower) with spectrum spread of 10 MHz or highercell

LoRa[edit]

LoRa can work with many frequency bands in the ISM band of frequencies, but the popular bands are

  • 868 MHz – EU (ITU Region 1)
  • 915 MHz – Americas (ITU Region 2)

In India the 865 MHz to 867 MHz license free band in India ends at 867 MHz, as per the Ministry of Communications and Information Technology directions as mentioned here despite being in the ITU. However the 868 MHz LoRa band has 8 channels and 7 of 8 frequency channels are in the license free 865 MHz – 867 MHz band in India.

TRAI Recommendation for M2M Spectrum[edit]

Industry recommendations for 10MHz were considered .

Request for unlicensing were 433-434 MHz, 902-928 MHz, 1880-1900 MHz, 2483-2500 MHz, 5150-5350 MHz, and 5725-5775 MHz. These demands reflect the widespread market adoption in countries where these bands have already become unlicensed.

on 5th Sep 2017 TRAI recommended 6 MHZ extra in 915-935 Mhz and 1 MHz extra at 867 MHZ.

It remains to be seen if these become final. In the past the defence forces , Prasar Bharati and ISRO etc have never vacated any spectrum.

Cellular spectrum[edit]

Primer on Spectrum in India


Network Bands Used in India[edit]

In India, GSM telephony works on two different frequency bands GSM900 and GSM1800 in MHz(mega hertz). Lower frequency network bands offers higher coverage while higher frequency network bands offers higher data speeds.

HSPA telephony in India works on two different network bands UMTS900 and UMTS 2100 in MHz. UMTS network bands are radio frequencies used by 3G. UMTS network bands in India are commonly deployed at 2100 MHz for better speeds.

LTE Technology in India make use of 3 network bands namely LTE850 (Band 5), LTE1800(Band 3), LTE2300 (Band 40). Band 3 provided great network coverage while Band 40 0ffers greater data speeds.


see Also[edit]